triprooflamps-blog

[triprooflamps-blog]

The rear cover is separated from the electrical cooling chamber and installed when the cover is powered off

DOD8830G deep-lighting LED explosion-proof lamp 100w is a lot of money DOD8830G deep-lighting LED explosion-proof lamp 100w is a lot of money DOD8830G deep-lighting LED explosion-proof lamp 100w is a lot of money Inquiry hotline: 13912332209 Mr. Tong 1, cold forged radiator, the cross section is hollow Cylindrical shape, increase the heat dissipation area; 2. Multiple heat dissipation: cold forged radiator, electrical heat dissipation cavity, light source cavity heat sink; 3. The electrical heat dissipation cavity is mainly used for multiple heat dissipation, due to the upward heat, it is dissipated in the cold forged heat sink The hot air is further dissipated through the heat dissipation cavity; secondly, a transformer is placed outside, and the heat sink can also distribute the heat generated by the transformer; 4. The tempered and transparent part is equivalent to a light bulb; 5. The light source cavity heat sink: existing What is not in the technology, it is mainly used to distribute the heat from the tempered and transparent parts; 6. Back cover: It is mainly used to cut off the power and open the cover;

The rear cover is separated from the electrical cooling chamber and installed when the cover is powered off. It consists of upper and lower installation; the upper part of the device is on the outside of the back cover, which is connected in a snap-fit ​​manner; first, the three recesses of the upper part correspond to the three notches of the back cover, and then the upper part is rotated, three Stuck into the slot, thereby snaps into the back cover; torsion spring is fixed to the prior art, but the torsion spring fixation means both hard and difficult to remove. 7.

The local and electrical radiator cavity under the power-off Ip65 led integrated lamp factory installation is also opposite to the connection method described above, both of which are buckle-type; the power-off installation is energized through the contact of the contact, and the power is disconnected when leaving. Implementation specifications: GB3836.1, GB3836.2 Explosion-proof mark: Exd II CT6 Gb Extra voltage: AC220V 50 / 60Hz (please specify if required) Protection level: IP66 Corrosion protection level: WF1 "WF2 introduction installation: G3 / 4 "Inlet specifications, suitable for Ф10mm-Ф14mm cable connection terminals: square meters of wire firmly connected device mode: X: ceiling type, b: wall type, g: boom type, f: flange type, h: guardrail type LED light source: 70W-120W lighting component: 6.2Kg