#but sadly I don't know anyone with a cricut or similar to make it

[nerdierholler]

IT'S DONE! I made a book! I never thought I'd ever be able to make a book. Sure mistakes were made but it was still a fun process and I learned so much from making this first one.

This a binding of The Wayhaven Chronicles IF but with my personal Detective's choices included and the resulting text smoothed out to read more like a novel.

Honestly, I thought something like this would be way beyond my skill set but it wasn't as scary as I thought once I got started. Definitely check out @renegadeguild for some book making and typesetting guides and their discord is super friendly and helpful as well.

If you want to learn from my mistakes I'll go into some trials and tribulations under the cut.

I'm not sure how well this book will hold up long term but that's ok! It was more about learning and I'll make some adjustments and try again with the same text probably.

Typsetting

Margins - need to make them bigger. I mostly read paperbacks so I was going for that format with narrower margins but then when I ran into paper problems, I didn't have a ton of room for trimming.

There was an option on the imposer to add dotted lines to the center fold and I clicked that but they're visible still even after binding. Could be that I needed to sew my signatures tighter and that would help but regardless I don't think I need them in the future so I'll be skipping that feature.

The font was intentionally small, along with the margins, because I was trying to minimize the number of signatures I was dealing with for a first project. I'll bump it up in the future.

Paper (so much wrong)

So the grain should run parallel to the spine but I couldn't find short grain paper. I read at some point that someone recommended using sketch books instead because that should be the right grain. It was not, at least not what I bought, so it still ended up going the wrong way.

The sketch note book I bought had perforated pages. It made them easy to get out but I didn't realize that the page widths were inconsistent until everything was printed out. The paper width varied by at least 1/8 of an inch. I wasn't planning on trimming my pages but my top was super uneven because of this so an attempt at trimming was made. It could have gone worse (there was no blood) but the trimming could have been a lot better too.

Should have just used printer paper. The results would have been the same.

Making Book Cloth

Used the Heat and Bond method with some spare fabric and it worked pretty well. The problem was when it came to adding backing. I'd read tissue paper or even plain paper so I grabbed some piecing paper that was close at hand. That was a mistake. It was good quality fabric so it was thicker already and the paper backing made it too thick. I could barely fold it over and it kept wanting to flip up. It's the spine fabric and I'm still concern it's going to do this in the future.

Used tissue paper for the marbled looking fabric and it was much easier to work with.

Book Board

Not measuring right was all on me. The rice box worked in a pinch but I think it will be prone to bending. Got me the experience I needed be wouldn't be my go-to material for a project of this size.

Glue

I used Elmer's All Purpose and it got the job done but, again, probably not going to hold up the best long term. However, I'm glad I didn't buy PVA and basically waste it on this project. Elmer's was good and cheap enough for practice. I'll be getting some PVA for future projects.